Alpine A110 2023 - Page 82

WIPER
1
80 - Getting to know your vehicle
Position C is accessible
with the ignition on.
Positions B and D are
accessible only with the engine
running.
B automatic wiper function
When this position is selected, the
system detects water on the
windscreen and triggers the wipers at
a suitable wiping speed. It is possible
to change the triggering threshold and
the interval between sweeps by turning
the ring 2 :
– E :minimumsensitivity
– F : maximum sensitivity
Note: in foggy weather or during
snowfalls, wiping is not automatically
triggered and the function remains
under the driver's control.
C. slow continuous wiping
D fast continuous wiping
Note:
– the rain sensor is only intended as a
driving aid. In the event of reduced
visibility, the driver should manually
activate the wipers. In foggy weather
or during snowfalls, wiping is not
automatically triggered and remains
under the driver's control;
– in the event of temperatures below
zero, automatic wiping is not activated
when the vehicle is started. It is
automatically activated as soon as the
vehicle exceeds a certain speed
(approximately5mph(8km/h));
– do not activate automatic wiping in
dry weather;
– fully de-ice the windscreen before
activating automatic wiping;
– when washing using a roller type car
wash, return the stalk 1 to the off
position A to deactivate automatic
wiping.
Windscreen washer
With the ignition on, pull the stalk 1
towards you.
A brief pull will trigger a single sweep
of the wipers, in addition to the
windscreen washer.
A longer pull will trigger three sweeps
of the wipers followed, a few seconds
later, by a fourth, in addition to the
windscreen washer.