Alpine CDA-117Ri - Installation and Connections Guide; Installation Warnings and Precautions; Connecting Devices and Components

42-EN
• The iPhone/iPod is not connected.
– Make sure the iPhone/iPod is correctly connected (refer to
“Connections” on page 47).
Make sure the cable is not bent excessively.
• There are no songs in the iPhone/iPod.
– Download songs to the iPhone/iPod and connect to this unit.
• Database error or decoder error.
– You can solve the problem by switching the source.
• Communication error or boot error, etc.
– You can solve the problem by reconnecting the iPhone/iPod or
changing source.
• The iPhone/iPod is not verified.
– You can solve the problem by reconnecting the iPhone/iPod.
• Abnormal current is run to the USB connector device.
– You can solve the problem by switching the source.
• A USB device that is not supported by the unit is connected.
– Connect a USB device that is supported by the unit.
Specifications
FM TUNER SECTION
MW TUNER SECTION
LW TUNER SECTION
CD PLAYER SECTION
PICKUP
USB SECTION
* Frequency response may differ depending on the encoder software/bit
rate.
GENERAL
CHASSIS SIZE
NOSEPIECE SIZE
Indication for iPhone/iPod Mode
Tuning Range 87.5-108.0 MHz
Mono Usable Sensitivity 0.7 μV
Alternate Channel Selectivity 80 dB
Signal-to-Noise Ratio 65 dB
Stereo Separation 35 dB
Capture Ratio 2.0 dB
Tuning Range 531-1,602 kHz
Sensitivity (IEC Standard) 25.1 μV/28 dB
Tuning Range 153-281 kHz
Sensitivity (IEC Standard) 31.6 μV/30 dB
Frequency Response 5-20,000 Hz (±1 dB)
Wow & Flutter (% WRMS) Below measurable limits
Total Harmonic Distortion 0.008% (at 1 kHz)
Dynamic Range 95 dB (at 1 kHz)
Signal-to-Noise Ratio 105 dB
Channel Separation 85 dB (at 1 kHz)
Wave length 795 nm
Laser power CLASS I
USB requirements USB 1.1/2.0
Max. Power Consumption 500 mA
USB Class Mass Storage
File System FAT 12/16/32
MP3 Decoding MPEG-1/2 AUDIO Layer-3
WMA Decoding Windows Media™ Audio
AAC Decoding AAC-LC format “.m4a” file
Number of Channels 2-Channel (Stereo)
Frequency Response
*
5-20,000 Hz (±1 dB)
Total Harmonic Distortion 0.008% (at 1 kHz)
Dynamic Range 95 dB (at 1 kHz)
Signal-to-Noise Ratio 105 dB
Channel Separation 85 dB (at 1 kHz)
Power Requirement 14.4 V DC
(11-16 V allowable)
Maximum Power Output 50 W × 4
Maximum Pre-Output Voltage 4 V/10 k ohms
Weight 1.6 kg (3 lbs. 8 oz)
Width 178 mm (7")
Height 50 mm (2")
Depth 160 mm (6-1/4")
Width 170 mm (6-3/4")