35-EN
When connect to Front USB Connection Terminal
1
Open the cover of the USB Connection Terminal.
2
Connect the Interface cable for iPod directly to the USB
Connection Terminal, or via the USB cable.
When connect to Rear USB Connector
Connect the USB cable to the Rear USB connector of the unit, and then
secure the connection using the lock case supplied with USB cable as
shown below.
Remove the iPod/iPhone
Remove the iPod/iPhone from Interface cable for iPod.
Notes
• This unit can charge the iPod/iPhone of the current source, and it may
stop charging when another source is switched.
• After changing the unit to a source other than the USB iPod, remove the
iPod/iPhone. If the iPod/iPhone is removed in the USB iPod mode, data
may cause damage.
• If sound is not output or the iPod/iPhone is not recognised even when
the iPod/iPhone is connected, remove the iPod/iPhone once, then
connect it again, or reset the iPod.
• Do not leave the iPod/iPhone in a vehicle for a long time. Heat and
humidity may damage the iPod/iPhone and you may not be able to play
it again.
Connect USB Memory
Connect the USB cable to the Rear USB connector of the unit, and then
secure the connection using the lock case supplied with USB cable as
shown below.
Remove USB Memory
Pull out USB Memory squarely from the USB cable.
Notes
• When removing USB Memory, pull it out straight.
• If sound is not output or USB Memory is not recognized even when
USB Memory is connected, remove USB Memory once, then connect it
again.
• Change to a source other than the USB Memory mode, then remove the
USB Memory. If the USB Memory is removed in the USB Memory
mode, data may be damaged.
• Route the USB cable away from another cables.
To Next Page
Loading...
