Alpine CDM-9807RB - SETUP Operations; Subwoofer on and off; Adjusting Source Signal Levels; Setting the AUX Mode (CDM-9807 RB;CDM-9805 R;CDM-9803 RM; CDM-9803 R Only)

16-EN
Setting the AUX Mode
(CDM-9807RB/CDM-9805R/CDM-
9803RM/CDM-9803R only)
You can input TV/video sound by connecting an
optional "M-Bus V-Link" (M-Bus/RCA interface
cable KCM-122B) to this component.
1 Press and hold the F/SETUP button for at least 3
seconds.
2 Press the g or f button to select the AUX
mode.
3 Press the BAND button to toggle the mode
between AUX ON and AUX OFF.
4 Press the F/SETUP button to return to normal
mode.
5 To adjust the volume, etc., first press the
SOURCE/POWER button and select the AUX
mode, then make the necessary adjustment.
→ TUNER → CD → AUX
NOTE
When AUX ON is selected, a CD Changer cannot be
used.
Subwoofer On and Off
1 Press and hold the F/SETUP button for at least 3
seconds.
2 Press the g or f button to select the SUB
(Subwoofer) mode.
3 Press the BAND button to select Subwoofer ON
or OFF.
4 After setting is completed, press the F/SETUP
button to return to normal mode.
NOTES
• Initial mode is "SUB-W ON."
• Set to "SUBW OFF" unless the subwoofer is used.
• When the subwoofer is turned on, the subwoofer
output level can be adjusted. For more details, refer
to the Adjusting Volume/Balance/Fader.
Adjusting Source Signal Levels
If the difference in volume level between the CD
player and FM radio is too great, adjust the FM
signal level as follows.
1 Press and hold the F/SETUP button for at least 3
seconds.
2 Press the g or f button to select the FM
LV (FM LEVEL) mode.
3 Press the BAND button to select the FM signal
level HI (High) or LO (Low) to make the signal
levels between the FM band and CD player
closer.
4 Press the F/SETUP button to return to normal
mode.
SETUP Operations
BAND
fg F/SETUP
SOURCE/
POWER