Alpine ERE-G180 - Operational Guide; Power, Subwoofer, and Equalizer Control; Volume, Tone, Fader, and BBE Mode Adjustment

ERE-G180
Operation Operation
English English
Turning Power On and Off Adjusting the Volume/Tone/
Fader Controls
“The ERE-G180 is tumed on and off automat
‘cally when your head units switched on and
ot
Adjust the volume and tone controls of your
ae head unt and the FADER control on the ERE-
Adjusting the Subwoofer ‘G180 to suit your listening preference.
Level fol Regardless of he EQUALIZER DEFEAT
Te ERE pts tse comet be f arnt, pe OUT LEVEL
bees dip epet ear tate levels. The input signal level is controlled by
Pedeelasbensiaihed duce petig eniat the volume contro of your head unit
the crossover point is continuously adustable,
input can be summed using the STEREO! ere ie
‘MONO switch and a PHASE switch provides 0 rege I tne reg ED lights Up: poninupusi
spec the output ofthe ERE-G180 could be
lial
ans
distorted.
Reduce
the
input
level
using
the head units volume control. The red
LED snoule only bght intermittent for
aoe The LED on te SUBWOOFER LEVEL conto! ne ‘optimum sound quay
ot, will be off when the SUBWOOFER ON/OFF
Switch sin the “OF poston. n this mode, a
the FRONT and REAR outputs will be full Ao:
Nee
range
signals
wth
no
sigal
othe
SUB-
t
WOOFER output
The LED onthe SUBWOOFER LEVEL contol
» wil luminate in arbor when the SUB-
. WOOFER ONOFF switch is nthe “ON
ton nhs mode, the FRONT and REAR
Chips wi be gh pase and ne SUS- Selecting the BBE Mode
WOOFER output wil rectve tho low-pass
signals.
Note: Push he SUBWOOFER ON/OFF ewten
to sel the subwooler mode to ON.
Push the swtch again ose he mode
torr.
Press the BBE swich to sat the ERE-G180 to
~ the BBE mode
Saas With each press, the BBE is toggled On or Ot
ae 120 Hz using the CROSSOVER Notes:
FREQUENCY. control ‘+ When the BBE switch is illuminated in
lmber, the BBE isn fect.
«CY + The BRE such wil be urinated amber
; vnhon tis inthe "ON" poston,
English
‘Adjusting the Equalizer and
Defeat Controls
4 SEEREREEEEE
vse ‘The EQUALIZER DEFEAT switch wil bo
fo uminated green when its in the “OFF*
position. In this mode, all the equalizer
B ‘settings are in effect. The LED indicators on
the EQUALIZER controls will be on
‘Note: The EQUALIZER DEFEAT switch wit
+ be illuminated amber when itis inthe
ON" position. n ths mode, the
equalizer sotings wit not effect the
as output (except for BBE if tuned on),
uF ‘The LED incicators onthe EQUALIZER
conto wil be of.