Alpine ERE-G180 - Connection Guide; Remote On Lead; Ground Lead; Battery Lead

ERE-G180
Connections/Connexions/Conexiones
© Remote On Lead (BLUEMWHITE)
Connect this lead to the remote turn-on lead of your head unit. Applying (+)12V to this lead turns on the
ERE-G180. If your head unit has a power antenna output that provides (+)12V when the unit power is
turned on, you may use that lead to turn the ERE-G180 on.
Ground Lead (BLACK)
‘Connect this lead to a good chassis ground.
‘Verity this point o be a true ground by checking continulty between this point and the negative terminal of
the vehicle's battery, For best results and immunity to vehicle induced noise, ground ail audio components,
at the same ground point
NOTE:
‘Secure the ground lead of the unit to bare metal on the car chassis using a sheet metal screw.
© Battery Lead (YELLOW)
‘Connect this lead to the positive (+) post of the vehicle's battery
=
ic)
Batterie
NOTE:
+12V is required on this line to turn on the ERE-G180. If your head unit does not have a remote-on or power-antenna tum-on wire, a SPST switch must
be connected between an ignition source and this terminal. Then, the ERE-G180 can be turned on.
Basic System/Systéme base/Sistema badsico
@
ee
Tar | wonatoor ron TEE arr
fessizon
fear bovo
@)) 4 Cr © ise of @ he
TAT 7p rare a
‘ampltcateur || Arpitcateur Arpitiatour nie prope
Amplificador Ampiificador | Amplificador Unidad principal
Front Rear Suowooters
avant Aree Sub-wocters
Delanero ——Trasero ‘Atvooes de tecvercas
aba
‘Speakers/Haut-parleurs/Altavoces,
® Front Output Connector
(to front speaker amplifier or signal processor)
9 Rear Output Connector
(to rear speaker ampilier or signal processor)
© Subwoofer Output Connector
(to subwoofer amplifier or signal processor)
‘© Input Connector
® PHASE Switch
‘The acoustical characteristics of different cars varies. When using subwoolers, standing waves may be
produced at low frequencies. These standing waves can cause cancellation and loss of performance at the
low end, To set the PHASE switch, listen to the system while switching the phase to 0 of 180°. Leave itn
the position which provides the best bass response,
O
"buns!
180" ot
STEREO/MONO Switch
It you have one subwoofer for your system, set the STEREO/MONO switch to the MONO position. When
Using two or more subwooters, the switch may be set to either MONO or STEREO. In the STEREO mode,
you may gain some sound separation (depending upon the music material). On the other hand, in the
MONO position, the subwoofers will share the load more equally and can play louder. Experiment to see
which sounds better for your application.
NOTE:
‘The PHASE and STEREO/MONO switches should be set before the installation is completed,
24s