4 5
Do-It-Yourself Installation
Here’s how to install your new eX-10 in your vehicle.
Push the display into the display mounting bracket
until you hear a “click”.
Step 1: Mount the display
*Note: Mount the eX-10 display in a location where it will not block your view of the road.
Attach the Bluetooth microphone to the micro-
phone mounting clip by pushing the microphone
onto the clip as shown.
Clip the microphone mount to a spot in your car
no more than 24” from your mouth.
Good locations include the sun visor, the top of
the A-pillar, and the edge of your roof-mounted
center console (if equipped)*.
*Note: Do not install the microphone in any position where it could interfere with the functionality of Airbags in
your vehicle. Consult your local car dealer for more information.
Step 2: Mount the Bluetooth Microphone
Do-It-Yourself Installation
Apply the supplied double-sided
tape to the bottom of the display,
clean the desired spot on your
dash* with the supplied alcohol
pad, then fi rmly stick the display
to the dash.
To Next Page
Loading...
