Assembling & Using Your Product
Unpack all components carefully. Please check to ensure all parts have been removed
from the packaging. There some splashing may occur.
Components:
A) Fountain
B) Submersible Pump
C) Back Cover
D) Transformer
Assembling:
1 Place the fountain (A) on a clean and leveled surface.
2 Connect the vinyl tubing and LED light cord from inside the back opening of the
fountain (A) into the pump (B) and adjust the flow control to the lowest setting to
avoid splashing until the fountain is completely assembled. (See above diagram
step 1 and 2)
3 Place the pump inside and at the bottom of the fountain’s (A) reservoir. Slide in
the back cover (C) and make sure to feed the pump power cord out to the back
cut out hole of the fountain. (See above diagram step 3)
4 Connect the pump (B) power cord to the transformer (D). (See above diagram
step 4).
5 Gently pour water into the fountain (A) basin, being careful not to overflow and
cause splashing. Make sure the water completely submerges the pump (B) and
the water runs clear during operation. (See above diagram step 5)
6 Plug the transformer (D) into your local power supply (See above diagram step
6) & make sure that there is no water around the plug & always keep the power
source in a dry place.
o NOTE: We recommend that you use distilled water to prevent scale
build-up. The first time you operate the pump it can take up to 5
minutes for the air to be completely expelled and water begins to flow
properly
Trouble Shooting & Caution
If you have any questions and/or problems, please contact the retail store you
purchased this fountain.
• If your pump fails to run
• Check the circuit breaker or try a different outlet to make sure the pump is
receiving electrical power.
• Check the pump discharge and tubing for any kinks and/or obstructions
• Any buildup obstructing the water flow can be flushed with a garden hose
• Check the rotor by removing the front cover & plate to access the impellor area.
Turn the rotor and make sure that the rotor is not jammed or broken
• If your pump “spews”
• Check the water level to make sure the pump is completely submerged and
they’re if enough water in the basin to operate your fountain. Not having enough
water will cause your pump to spew
• If your pump is making abnormal loud noises
• Disconnect the pump from the electrical power supply and remove the front
cover & plate
• Carefully grip the impellor and gently pull the impellor/rotor assembly out
of the pump housing
• Rinse the impellor/rotor assembly and clean the cavity with clean water. If
breakage or damage is found, contact your local retailer for parts
• Caution
o Always unplug the pump from the electrical outlet before
cleaning & handling
o Uses with clean water only, do not place the fountain and/or
parts in any other liquid.
o Periodically change water & clean the pump to keep free
from micro-organisms
o Disconnect and store the unit in a dry place if not in use for
an extended period of time
o Do not operate with water above 90°F or 30°C
o Do not lift, carry or pull the pump by the power cord
o Do not exceed the maximum voltage & wattage on
transformer
o NEVER LET THE PUMP RUN DRY
To Previous Page
Loading...
