~
WARNING
This symbol means
important
instructions. Failure
to
heed
them
can result in serious injury or death.
DO
NOT
DISASSEMBLE
OR
ALTER.
Doing so may result in an accident, fire
or
electric shock.
KEEP
SMALL
OBJECTS
SUCH
AS
SCREWS
OUT
OF
THE
REACH
OF
CHILDREN.
Swallowing them may result in serious injury.
If
swallowed, consult
a physician immediately.
USE
THE
CORRECT
AMPERE
RATING
WHEN
REPLACING
FUSES.
Failure to do so may result in fire
or
electric shock.
DO
NOT
BLOCK
VENTS
OR
RADIATOR
PANELS.
Doing so may cause heat to build up inside
and
may result in fire.
USE
THIS
PRODUCT
FOR
MOBILE
12VAPPLICATIONS.
Use for other than its designed application may result in fire,
electric shock
or
other injury.
MAKE
THE
CORRECT
CONNECTIONS.
Failure to make the proper connections may result in fire
or
product damage.
USE
ONLY
IN
CARS
WITH
A
12
VOLT
NEGATIVE
GROUND.
(Check with your dealer if you are not sure.) Failure to do so may
result in fire, etc.
BEFORE
WIRING,
DISCONNECT
THE
CABLE
FROM
THE
NEGATIVE
BATTERY
TERMINAL.
Failure to do so may result in electric shock
or
injury due to
electrical shorts.
DO
NOT
ALLOW
CABLES
TO
BECOME
ENTANGLED
IN
SURROUNDING
OBJECTS.
Arrange wiring and cables in compliance with the manual to
prevent obstructions when driving. Cables
or
wiring that obstruct
or
hang up on places such
as
the steering wheel, gear lever, brake
pedals, etc. can be extremely hazardous.
DO
NOT
SPLICE
INTO
ELECTRICAL
CABLES.
Never cut away cable insulation to supply power to other
equipment. Doing so will exceed the current carrying capacity
of
the wire
and
result in fire
or
electric shock.
DO
NOT
DAMAGE
PIPE
OR
WIRING
WHEN
DRILLING
HOLES.
When
drilling holes in the chassis for installation, take precautions
so as not to contact, damage
or
obstruct pipes, fuel lines, tanks
or
electrical wiring. Failure to take such precautions may result in fire.
2 -EN
DO
NOT
USE
BOLTS
OR
NUTS
IN
THE
BRAKE
OR
STEERING
SYSTEMS
TO
MAKE
GROUND
CONNECTIONS.
Bolts
or
nuts used for the brake
or
steering systems (
or
any other
safety-related system),
or
tanks should NEVER
be
used for
installations
or
ground connections. Using such parts could disable
control
of
the vehicle and cause fire etc.
DO
NOT
INSTALL
IN
LOCATIONS
WHICH
MIGHT
HINDER
VEHICLE
OPERATION,
SUCH
AS
THE
STEERING
WHEEL
OR
GEARSHIFT.
Doing so may obstruct forward vision
or
hamper
movement etc.
and results in serious accident.
DO
NOT
INSTALL
THE
MONITOR
NEAR
THE
PASSENGER
SEAT
AIR
BAG.
If
the unit
is
not installed correctly the air bag may not function
correctly
and
when triggered the air bag may cause the monitor to
spring upwards causing an accident and injuries.
~CAUTION
This symbol means
important
instructions. Failure
to
heed
them
can result in injury or material
property damage.
HAVE
THE
WIRING
AND
INSTALLATION
DONE
BY
EXPERTS.
The wiring
and
installation
of
this unit requires special technical
skill and experience.
To
ensure safety, always contact the dealer
where you purchased this product to have the work done.
USE
SPECIFIED
ACCESSORY
PARTS
AND
INSTALL
THEM
SECURELY.
Be
sure to use only the specified accessory parts. Use
of
other than
designated parts may damage this unit internally
or
may
not
securely install the unit in place. This may cause parts to become
loose resulting in hazards
or
product failure.
ARRANGE
THE
WIRING
SO
IT
IS
NOT
CRIMPED
OR
PINCHED
BY
A
SHARP
METAL
EDGE.
Route the cables and wiring away from moving parts (like the seat
rails)
or
sharp
or
pointed edges. This will prevent crimping and
damage to the wiring. If wiring passes through a hole in metal, use a
rubber grommet to prevent the wire's insulation from being cut by
the metal edge
of
the hole.
DO
NOT
INSTALL
IN
LOCATIONS
WITH
HIGH
MOISTURE
OR
DUST.
Avoid installing the unit in locations with high incidence
of
moisture
or
dust. Moisture
or
dust that penetrates into this unit may
result in product failure.
To Next Page
Loading...
