Alpine iLX-F259 - Getting Started; Location of Controls; Turning Power On or Off; Initial System Start-Up

2) After adjustment, tightly fix the display with the 4 Flush head
screws (M4x13) for up-down adjustment.
Flush head screw(M4x13)
(left and right)
3) Adjust the angle of the display.
Refer to the illustration below to use the screw holes for angle
adjustment.
• Example:
To install the display at the angle of 20°, use the screw holes 2
andb.
-20°
r,, : =-,
"'I-
. -
I• •
•~
20°
45°
4) After adjustment, secure the display with the 2 angle
adjustment screws (M4x6) (left and right) that were removed
in Step 1 on page 5.
Angle adjustment screws (M4x6)
(left and right)
7-EN
I