Alpine IVA-D901 - Dolby Surround Adjustment Procedure; Phone Book and Call History; Calling from Address Book; Using Call History

42-EN
Calling by the address book
From your vehicle, call from the address book registered in the
portable telephone.
1
Press and hold the Rotary encoder for more than
2 seconds.
The Speed Dial display appears.
2
Press 7 (RETURN).
The Telephone menu display appears.
3
Press 2 (PHONE BOOK).
The Phone Book display appears.
4
Turn the Rotary encoder to select a receiver,
then press the Rotary encoder .
The Select display appears.
• By pressing 1 (ALPHABET DN) or 2 (ALPHABET UP),
the names are listed in alphabteical order.
• If no data is in the PHONE BOOK, "NO MEMORY" is
displayed.
Press 7 (RETURN) to return to the Telephone menu display.
5
Press 1 ( ) to place the call.
6
To cut the call, press 2 ( ). Or the call is
automatically cut in 5 seconds after finishing.
Calling by the outgoing / incoming /
absent incoming history
You can place a call to one of the last 999 calls by the outgoing/
incoming/absent incoming history.
1
Press and hold the Rotary encoder for more than
2 seconds.
The Speed Dial display appears.
2
Press 7 (RETURN).
The Telephone menu display appears.
3
Press 3 (CALL LOG).
The Call log display appears.
4
Press either 1 (DIALED NUM.), 2 (MISSED
CALLS) or 3 (RECEIVE CALLS).
DIALED NUM.: Outgoing history list display
MISSED CALLS: Absent incoming history list display
RECEIVE CALLS: Incoming history list display
• If no history is registered to any of the lists, NO MEMORY is
displayed.
To return to Telephone menu display, press 7 (RETURN).
5
Turn the Rotary encoder to select a receiver, then
press the Rotary encoder.
The Select display appears.
6
Press 1 ( ) to start call.
7
To cut the call, press 2 ( ). Or the call is
automatically cut in 5 seconds after finishing.
SMS (Short Message Service) Operation
You can receive messages, show the contents of messages, and send
standardized sentences.
When a message is received, an icon is indicated on the display.
Receiving a Short Message
1
Press the Rotary encoder for more than 2
seconds.
The Speed Dial display appears.
2
Press 7 (RETURN).
The Telephone menu display appears.
3
Press 5 (SMS READ).
The SMS Read display appears.
4
Turn the Rotary encoder to select one of the
received message.
5
Press the Rotary encoder.
The SMS Inbox display appears.
The contents of the received message is displayed up to
140 letters.
REPLY: Replies to the sender by return mail.
Standardized sentences can be selected
in the display (refer to “Sending a
Standardized Sentence,” page 43).
USE NUMBER: Replies to the sender by phone. The
Select display appears. Place a call by
pressing 1 ( ).
RETURN: Returns to the SMS Read display.
• When the unit receives a message, the new reception icon appears.