Alpine iXA-W404 - System Setup and Output Configuration; Picture Output and Bluetooth Connection

24-EN
Outputs the picture of the source selected on the iXA-W404 connected
to the rear monitor.
Setting item: AUX OUT
Setting contents: OFF / ON
Setting item: Bluetooth IN
Setting contents: OFF / ADAPTER / NAV.
• When this unit is connected to the optional BLUETOOTH
INTERFACE (KCE-400BT), Bluetooth IN is not set to NAV.
• For details on Bluetooth operation, refer to the Owner’s Manual of
the BLUETOOTH INTERFACE (KCE-400BT).
• If the mobile phone compatible with the Voice Dial function is
connected, the Voice Dial function can be used.
If a USB Adapter is to be used, set to ON.
Setting item: USB Adapter
Setting contents: OFF / ON
• If ON is set even when a CD changer is connected the source name
on the Audio/Visual source selection screen will change from CD
CHG. to USB.
An external device (such as a portable music player) can be connected
to the Bluetooth interface connector of this unit. A special Conversion
cable (KCE-237B) is necessary to adapt the Bluetooth interface
connector as an AUX IN.
Setting item: AUX+ IN
Setting contents: OFF / ON
• When OFF is selected, the settings related to AUX+ cannot be
changed from this unit.
• Only when an Alpine TV tuner is connected, you can operate the
displayed function guide from this unit.
After setting to ON in “Setting the AUX+ Mode”, this setting can be
carried out.
Setting item: AUX+ Level
Setting contents: LOW / HIGH
Setting the Picture Output
OFF: The “RSE” item is not displayed on the mode switching
screen.
ON: The “RSE” item is displayed on the mode switching
screen.
Touch [RSE] to change to the REAR selection screen,
and then touch the desired source. The selected source
picture is output on the rear monitor.
Setting the Bluetooth Connection
(Bluetooth IN)
OFF: Select to ignore any external interrupts.
ADAPTER : Select when the optional BLUETOOTH INTERFACE
(KCE-400BT) is connected.
The TEL screen of the Bluetooth is displayed.
When an external interruption occurs, the display
changes to the TEL screen.
NAV.: Select when the optional portable navigation is
connected.
The TEL screen of the portable navigation is displayed.
Setting the USB Adapter to ON/OFF
OFF: Does not display the USB source name on the Audio/
Visual source selection screen.
ON: Displays the USB source name on the Audio/Visual
source selection screen.
Setting the AUX+ Mode
OFF: AUX+ source is not displayed.
ON: AUX+ source is displayed.
Adjusting the AUX+ Audio Level
LOW: Decreases the external input audio level.
HIGH: Increases the external input audio level.