35 36
Preperation: Rear Door
Take the hole punch and mark out the pre cut holes of the template. These will help
with precision drilling.
49
With holes marked. Pre drill your door card. 3mm and 6mm drill bits are required for
this step.
50
Preperation: Rear Door
With the template still in place. Use a marker to draw an oval on the back of the door
card which will be cut out for speaker clearance.
51
Cut the speaker clearance hole in the door card. We recommend a jigsaw for this step.
Cut outside the line to ensure proper clearance.
52
To Next Page
Loading...
