To Next PageTo Next Page
Need help?Do you have a question about the Alpine MRD-M1001 and is the answer not in the manual?
General| Crossover Frequency | 50Hz - 200Hz |
|---|---|
| Number of Channels | 1 |
| RMS Power @ 2 Ohms | 1000 Watts |
| THD at Rated Power | 0.1% |
| S/N Ratio | 100dB |
| Damping Factor | 200 |
| Bass Boost | 0 - 18 dB |
| Weight | 7.5 lbs |
| THD | 0.1% |
Avoid distractions and maintain awareness of surroundings while driving.
Handle wiring, fuses, voltage, ventilation, and connections properly.
Heed important instructions to prevent injury, death, or property damage.
Mount in a location with free air circulation; mark, drill, and secure with screws.
Ensure secure ground connection to chassis for noise elimination.
Connect battery lead to positive terminal; secure ground lead to chassis.
Connect positive to positive, negative to negative, avoid chassis connection.
Connect RCA input to head unit line outs; use Pre-Out jacks for other components.
Check wire size and remove appropriate insulation for secure connections.
Properly insert and tighten wires into terminals, using protective tubing.
Remove screws to open the terminal cover door.
Secure the terminal cover to the unit using screws.
Guide to the 10 adjustment modes and button functions.
Notes on functions not supported by remote and display differences.
Press DISP button to cycle through display information.
Match head unit output level to amplifier input for optimal gain.
Use MODE, ENT, and directional buttons to select input mode.
Set input level to match head unit output (0.1-8.0V range).
Set the gain factor level (0dB to +9dB range).
Activate or deactivate the Low Pass Filter using MODE and ENT buttons.
Set the crossover frequency (30-200Hz) and slope (12dB/24dB) for the Low Pass Filter.
Activate or deactivate the Subsonic Filter using MODE and ENT buttons.
Set the frequency (15Hz-50Hz) for the Subsonic Filter.
Control and adjust equalizer frequency, width, and level settings.
Set the Q value (width) and level (+/-12dB) for the Parametric Equalizer.
Turn Bass Compensation on/off and select mode (COMP1/COMP2/COMP3).
Turn Time Correction on/off and set delay time (0-10ms).
Select speaker phase (0° or 180°).
Assign a unique ID to the amplifier for multi-amp systems.
Set the amplifier's turn-on delay time (0.0-2.0s).
Temporarily disable audio output for adjustments; turn off after use.
Select memory slot and choose 'SAVE' or 'LOAD' to store/retrieve settings.
Diagnose and resolve low volume or no sound output problems.
Understand HOT, TEMP, VOLT, CURR indicators for problem diagnosis.
Wiring diagram for a single-speaker setup.
Wiring diagram for a parallel-speaker setup.
FCC compliance, serial number recording, and installation technician info.
