11
Connect the power lead to this unit.
Insert until a click sound is heard.
4
Wrap electrical tape around end of leads not used.
Connect the battery (–) terminal and turn the ignition key to the ACC or ON
position. Check to see if operation can be performed properly.
(Is the power turned on? Is the illumination turned on?)
You can check the language selection menu with the monitor. (Refer to the Owner’s Manual for details.)
Go to step 7 after checking is completed.
ON
5
6
Turn the ignition key to the OFF position to turn off the
power after completion of the check.
7
Pull out the ignition key and remove the battery
terminal (–) again to begin installation procedure.
8
OFF
To Next Page
Loading...
