6
Routing the aerial cable.
1. Route the cable using the provided cable clampers to take up
the cable’s slack.
2. Use the waterproof pad when running the cable under the
vehicle’s rubber gasket.
3. Attach the cable at several points using the remaining cable
clampers.
Cable
clamper
2. Connections
Disconnect the battery (–) terminal.
Note:
Some vehicles contain a vehicle control computer etc. in this case, contents of
the computer memory may be erased when the battery (–) lead is disconnected.
Water
proof pad
6
1
Cut terminal leads as required, and attach the solderless connectors to the leads.
Note:
For leads which need branching to the speed sensor, dimmer, parking brake, etc., use the solderless
connectors.
2
How to Connect
3
12
Vehicle lead
Solderless connector (supplied with the unit)
Navigation side lead
Navigation side lead
Stopper
Pliers
Preparation
To Next Page
Loading...
