Factory
Equipment
Removal
Process
(continued)
7 Release the glove
box
compartment
by
pressing
both
Right and Left side tabs
towards
each other.
9 Tilt the passenger seat towards the
back
to
reveal
(4)
connectors. Disconnect and remove the seat.
Installation
1 Connect the
power
cable
to
the Positive(+)
battery terminal
at
the fuse
block
in the engine
compartment
and route the cable towards
the
passenger side as shown below. Note: The
negative terminal should remain disconnected unit
the installation is completed.
:M,f•t«'Wffl
e 5/11
8 Using a
TSO
Torx socket extract
(4)
Torx screws
from the passenger side seat.
2 Route
the
power
cable thru
the
rubber
grommet
on
the
firewall on the passenger side.
To Next Page
Loading...
