10
TROUBLESHOOTING
Only One Speaker Has Sound
• Make sure both speakers have sufcient power, are turned on and
within 25 feet of each other.
- If a speaker doesn’t have enough power, it will beep every 30 seconds.
Charge your speaker fully before pairing to each other or to your
device.
- When the Speaker is charging by Micro USB the Charging Indicator
light turns RED. When the Speaker is fully charged the Charging
Indicator light turns GREEN.
• Make sure both speakers are paired to each other. When you are
not playing music, if both speakers have their Bluetooth Indicator
Light lit steady BLUE, it means they are paired to two separate
devices.
- If the second device is not in range, you can disconnect it and pair the
two speakers. Press and hold the Function button to begin pairing.
- If the second device is in range, unpair the speaker from that device.
On your device’s Bluetooth settings, select “Alpine Corporation” and
press unpair or disconnect.
- Press and hold the Function Button and follow steps for “Pairing Two
Speakers to a Bluetooth Device”
- Only one speaker should have a ashing light after this is performed.
• You must have only one “Alpine Corporation” in your Bluetooth
List. If your device shows “Alpine Corporation” twice on your
Bluetooth List, you must remove both on your device:
- iOS devices: go to settings>Bluetooth> click the (i) icon > forget
device
- Android devices: go to settings> Bluetooth > click Gear icon> click
unpair
- Then follow the steps for “Pairing Two Speakers to a Bluetooth
Device”.
To Next Page
Loading...
Need help?
General
