Alpine TDA7556R - Page 63

e. Replacement of the lever lock/lever mode
switch/roller mode
(1) After removing the rack mode, remove the lever
lock and lever mode switch. (Refer to Figure 8)
(2) Pull it up from the stud and remove the two roller
mode @), © as shown in Figure 8.
(3) Apply the molykote G paste to the section D-1,
the grease (PG-671) to the section D-2 and mount
the roller mode/lever mode switch/lever lock
following the removal steps in the reverse order.
NOTE : @ Check to see the roller mode is
inserted without fail.
e. LN-AyI/SUIN-E-— KAZ yy FS
A-F-—€-KORRAB
FPyTE-KFEALER, LIN-OyZ,
LN-E-FAL yF OMICS REET.
(Bisé Fe)
(2) MAMA-FS-E-KF@O.OFARY REY
5\XREET, (MBBRR)
D-1BSICEYVA-bGN-Ak, D-2BD
(CFU A (PG-671) BAL. RUALA
DHOFIRCRYU TET.
GEE) OO-F-T-KORARNPAUZE,
(1)
(3)
Head
Pinion motor
f. Replacement of gears
f-1 Replacement of the RF gear
(1) Remove M1.2 lock washer @), pull it up from the
stud and remove the gear as shown in Figure 8.
(2) Mount it, following the removal steps in the
reverse order.
f-1 RF¥PORRAKE
(1) Ox777DyyY4—@ (M12) EAL. ZB
KWQ5XRELPVEALET, (MBER)
(2) RUA LADHOFBCRYUAUET.
f-2 Replacement of the take-up gear
(1) Remove M1.2 lock washer@), pull it up from the
stud and remove the gear as shown in Figure 8.
(2) Mount it, following the removal steps in the
reverse order.
NOTES on f-1 and f-2 :
@ Do not reuse the used lock washer
for remounting.
@ Take care to avoid damage by
piercing and tearing.
2 FLIP yy SEVP ORBAE
(1) 2OAyA7DyyY+—@® (M1.2) EAL,
ARy KEV EREXPREALET. (MOB)
(2) RUM LADBOFIBCRUAWET.
[f1, {20 733%]
O-EB@RLEAyIDy > +-ld
MAAR SEALE CRA,
@AyvyIDyyvr—BD) ft ithe, ORK.
OC NOAWVRICERTSZEL,
@ Main motor
Control! P.C.Board
Figure 10
me oe
GR-S
SERIES