Assembling & Using Your Product
Unpack all components carefully. Please check to ensure all parts have been
removed from the packaging. Some splashing may occur.
Components:
Fountain
LED Light
Submersible Pump
Transformer
Assembling Instructions:
A. Place the fountain base on a smooth and level surface.
B. Next remove the LED light cord from the opening in the back of the
fountain. Then connect the LED light cord to the transformer by inserting
the male two-prong socket into the female plug of the transformer (see
figure 1 above).
C. Gently pour water into the fountain, being careful not to overflow and
cause splashing. Make sure the water completely submerges the pump
so the water runs clear during operation (see figure 2 above).
D. Plug the cords for the LED lights and pump into your local power supply.
Make sure that there is no water around the plugs and always keep the
power source in a dry place (see figure 4 above).
o NOTE: We recommend that you use distilled water to prevent
scale build-up. The first time you operate the pump it can take
up to 5 minutes for the air to be completely expelled and water
begins to flow properly.
Trouble Shooting & Caution
If you have any questions and/or problems, please contact the retail
store you purchased this fountain.
If your pump fails to run
Check the circuit breaker or try a different outlet to make sure the
pump is receiving electrical power.
Check the pump discharge and tubing for any kinks and/or
obstructions
Any buildup obstructing the water flow can be flushed with a garden
hose
Check the rotor by removing the front cover & plate to access the
impellor area. Turn the rotor and make sure that the rotor is not
jammed or broken
If your pump “spews”
Check the water level to make sure the pump is completely
submerged and there if enough water in the basin to operate your
fountain. Not having enough water will cause your pump to spew
If your pump is making abnormal loud noises
Disconnect the pump from the electrical power supply and remove
the front cover & plate
Carefully grip the impeller and gently pull the impeller/rotor
assembly out of the pump housing
Rinse the impeller/rotor assembly and clean the cavity with clean
water. If breakage or damage is found, contact your local retailer for
part
Fountain Care
We recommend to use Alpine’s all natural cleansing formula to
eliminate foam, lime scale and calcium buildup, fight mineral
deposits, leave water crystal clear, help prevent staining, remove
organic contaminants and treat discolored water. This formula will
help prevent pump damage due to hard water build up.
i. For small sized fountains holding water up to 7liters of
water, we recommend Alpine Item # PPL100
ii. For larger sized fountains holding water over 7liters of
water, we recommend Alpine Item # PPL102
iii. For more information please visit www.alpine4u.com
Caution
o Always unplug the pump from the electrical outlet
before cleaning & handling
o Use with clean water only, do not place the
fountain and/or parts in any other liquid.
o Periodically change water & clean the pump to
keep free from micro-organisms
o Disconnect and store the unit in a dry place if not
in use for an extended period of time
o Do not operate with water above 90°F or 30°C
o Do not lift, carry, or pull the pump by the power
cord
o Do not exceed the maximum voltage & wattage on
transformer
To Previous Page
Loading...
