Why is the red LED flashing on my Alpinestars Tech-Air 10 System Motorcycle Accessories?
If your Alpinestars Motorcycle Accessories are showing a flashing red LED while the green LED is on, it means the battery is low. Recharge the battery as soon as possible.
What to do if Alpinestars Tech-Air 10 System LED display LEDs blink?
If the LEDs on your Alpinestars Motorcycle Accessories LED display blink for a second, it indicates that the LED display battery is low, specifically with less than 4 hours of charge remaining. To resolve this, position the LED display on the docking area to recharge it. Ensure a proper connection and verify that the LED display shows its battery level during charging.
Why is there a solid yellow LED on my Alpinestars Tech-Air 10 System?
A solid yellow LED (3b) displayed while the green LED (3a) is on in your Alpinestars Tech-AirĀ® 10 Motorcycle Accessories indicates that the system is performing a system check. This involves speed or wearing detection, depending on whether you're in Race or Street Mode. This is normal operation as the system prepares to enter the protecting airbag mode.
What to do if Alpinestars Tech-Air 10 System Motorcycle Accessories LED display does not switch on?
If the Alpinestars Motorcycle Accessories LED display doesn't switch on when the activation belt is closed, several factors could be at play. First, the system battery might be completely discharged; in this case, recharge the battery and monitor the LED behavior during recharging. Note that if the battery is extremely low, the LED display might not activate until it reaches an adequate charge level. Secondly, the LED display battery itself could be fully discharged; to resolve this, place the LED display on the docking area and verify the battery level. Again, the display might not activate if the battery is too low until sufficient charge is achieved. Thirdly, ensure that the activation belt is correctly positioned on the hook-and-loop patch. Lastly, the gas inflators might be empty, or ...
Details system activation, Race/Street modes, and system checks.
Explains the procedure for turning off the System and its importance.
Instructions for cleaning the back protector and airbag components, with warnings.
Guides on washing the base layer and reassembling System components after cleaning.
Covers app registration, Bluetooth pairing, and initial setup of the System with the app.
Explains how the app displays system status, operating mode, and deployment alerts.
General| Airbag Coverage | Full upper body coverage |
|---|---|
| Bluetooth | Yes |
| Type | Airbag System |
| Protection | Chest, Back, Shoulders |
| Sensors | 3 gyroscopes and 3 accelerometers |
| Battery Life | 25 hours |
| Weight | 1.5 kg |
| Compatibility | Compatible with Alpinestars jackets |
| Activation | Automatic |
| App Compatibility | Tech-Air App |
| App Features | System status, firmware updates, crash data |
| Certification | CE certified |
| Connectivity | Bluetooth |
To Next Page