USER MANUAL / ENGLISH
Turn off the system, open the zipper on the airbag and
unhook the 5 hooks.
Open the backpack and the strap pocket. Detach the trigger handle. Remove the trigger handle
through the opening between the shoulder strap and the airbag compartment.
Remove the compressor through the side of the airbag compartment
12 INSTRUCTIONS
REGULAR CHECKS
Your ALPRIDE avalanche backpack requires no maintenance but the following points have to be observed:
1- Deploy the airbag before the new season starts or at least once a year or after the backpack has been exposed to moisture / wet weather. Check
its condition, allow it to dry and fold it back together again.
2- Pack the airbag away only when it is completely dry.
3- Prior to every tour, check all the points described in this user manual and inspect the condition of the system’s safety straps and fastenings.
Practice deploying the airbag so you have a feel for the amount of force you need to apply. In the event of a real avalanche, you will then be able to
deploy it correctly and intuitively.
13 MAINTENANCE
POST-AVALANCHE CHECK
Every use of the ALPRIDE E2 AIRBAG system can negatively affect the material. Often the damage is not visible with the naked eye. After a use in
an avalanche, contact ALPRIDE.
ALPRIDE E2 AIRBAG system for further inspection.
If you are unable to send the ALPRIDE E2 AIRBAG system, then following points are recommended to check:
• Check the airbags visually for punctures.
• Check the airbag fastening straps for tears.
• Check the shoulder, waist and chest straps as well as the seams for tears.
• Check all buckles (adjustment buckles at the shoulder straps, waist and chest strap).
• Check buckles as well as leg straps for tears and deformation.
HOW TO REMOVE THE DETACHABLE AIRBAG SYSTEM
11
To Next Page
Loading...