EasyManua.ls Logo

Alpride E2 - Autonomy of the E2 System; Deflating and Re-folding the Airbag

Alpride E2
15 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
USER MANUAL / ENGLISH
AUTONOMY OF THE E2 SYSTEM
The system’s autonomy depends on the quality and energy of the AA batteries and the frequency and duration of use in ON or OFF mode. The times
listed below assume the use of high-quality alkaline batteries:
Approx. 2-3 months of autonomy with two new AA alkaline batteries not including recharge of the SuperCapacitors (new batteries inserted after
recharging the SuperCapacitors)
The system can be used without additional AA batteries. However we strongly suggest to always use it with the batteries to ensure extended
autonomy.
NOTE:
If the system is charged with the USB-C and used without batteries, it will only have a maximum autonomy of 12 to 24 hours, which is perfectly
normal because the AA batteries ensure the autonomy of the E2.
10 DEFLATING AND RE-FOLDING THE AIRBAG
The airbag should be deflated using the airbag’s draining knob. Lift the safety cover of the deflation button and press the button to deflate the airbag.
Once the airbag is deflated, the springs on the safety cover automatically close it.
To fold the airbag, see the folding scheme.
WARNING: The deflation button is equipped with an orange
indicator to ensure that the deflation button has returned to the
upper position and thus does not keep the check valve in the
deflation position.
If the orange indicator is visible, this means that the deflation
button has not returned to the initial position and could keep
the check valve open. In this case, check that snow or ice is not
blocking the deflation button in the pressed position.
Do not use the E2 if the deflation button is jammed (orange
indicator visible).
After each deflation, check that the orange indicator is not
visible.
Deflate the airbag by pressing
the deflation button
Bring the slider to the beginning of the zipper Assemble the two parts of the zipper
If necessary, separate the slider from the zipper by pulling
the slider down and the other half of the zipper to the side.
Folding complete
8