6490009ENLZ / 6790009ENLZ
►
16
◄
Conditions of use on site Alsipercha System
Alsipercha Body Review Procedure - 84411, column clamps - 83424,
column clamp sleeve - 83426 and Tripod for unlading trucks - 84475,
83472, 84478, 83473 inspection procedure.
Control guidelines Procedure
Place the Alsipercha system on two
trestles and open it up to:
- Check that the bolts, pins, and nuts of the
various extensions are in good condition
and that they can move freely.
- Check that the extensions are neither
askew nor misshapen (maximum
tolerance in both directions is 5 mm).
Pay special attention to ensuring that the
diagonal tube with spring is straight.
- Clean the concrete and particularly some
areas between the two lugs, as this is the
area where various hanger accessories
are housed. If these are closed, open
them with a hammer, until the beam can
enter.
- Inspect the welds, especially on the ring
to which the hood is attached.
If problems are
identifi ed with any
of the above,
contact the Alsina
Service Department.
Warning - Never remove the Alsipercha Body’s diago-
nal tube. Handling the tube may be dangerous. If any
problem is observed in this diagonal, contact the Alsina
Commercial Technician.
Hook Review Procedure - 83418
Control guidelines Procedure
- Check that the hook is neither askew nor
misshapen.
If the deformation is
minor, it can be fi xed
provided that the
tube structure is not
misshapen.
- Clean the concrete.
- Check that there are no fractures.
Appendix 1: Conditions of use on site
Below are the guidelines for reviewing each component of the Alsina
Alsipercha Fall Arrest System. Reviews should be performed regularly,
once per year at the very least.
As explained in Alsina's Alsipercha Assembly and Safety Manual,
this review does not replace the visual inspection that the user should
perform each time he or she uses the Fall Arrest System.
Retractable Review Procedure - 8441201 / 84439
Control guidelines Procedure
Check that the belt
winds automatically
and unwinds normally along its whole
length.
If it does not work,
remove from service
since it is faulty
.
Check that the locking function is, by
pulling the belt sharply and observing that
it locks.
If it does not work,
remove from service
since it is faulty
.
That the textile is in perfect condition,
without tears or loose ends.
If it does not work,
remove from service
since it is faulty
.
That the metallic parts
are not oxidised
and that the karabiners work and
block
correctly
.
It is important to check that the continuous
energy absorber protected by the plastic
and the fi bres
forming it, have not
broken
.
If it does not work,
remove from service
since it is faulty
.
To Next Page
Loading...