6490009ENLZ / 6790009ENLZ
►
15
◄
General usage considerations Alsipercha System
To prevent objects falling onto people and/or materials during hoisting,
loading or unloading operations, using trays or transport containers,
always following the manufacturer's instructions, is recommended.
Alsina provides the ALSINA CONTAINER item. Alternatively, they can
be lifted using slings, distribution beams, rocker arms, etc. in packages
strapped at both ends, hanging the load, thus avoiding horizontal
displacement of the stable assembly. Lifting systems must be with
closed hooks. The crane worker, who will have received the proper
training, shall always be responsible for fi nal review of the attachment
of the load.
Stacking the ALSINA CONTAINER more than three high is not
recommended. They must be stacked on a stable, fl at area.
Simultaneous movements shall not be carried out with the crane.
Loads must be hoisted using mechanical equipment, with a load
capacity suffi cient for the load being lifted.
Equipment Maintenance
A pre-established expiration date cannot be established for formwork,
but improper use of equipment that could cause damage to it must be
avoided.
Alsina, S.A. supplies the formwork material and is responsible for
delivering the equipment in good working condition, in accordance
with the criteria in our quality manual. When assembly is not carried
out by Alsina, the user must accept responsibility for proper use and
maintenance of the equipment.
The users are always responsible for maintaining all equipment,
whether rented or the customer's own property.
When assembling, the material must always be checked by a qualifi ed
individual who will verify that the equipment is apt for use or reject it,
especially in the event of a person falling. There are specifi c control
guidelines for using the main components of the system on site.
These are detailed in the appendix at the end of this section
(Appendix 1). In accordance with these criteria, when a part that is not
fi t for use is identifi ed, it must be rejected, avoiding the use of defective
or damaged parts.
The condition of the material must be checked before the start of a day
after strong winds, rains, snow, etc. since it is possible that a part could
have been dropped, displaced, loosened or damaged.
Annex: Regulationsin Spain
Spanish legislation requires that assembly and dismantling of the
system must be performed by personnel duly trained, as described
in Law 31/1995 and the modifi cations to this law contained in Law
54/2003, for work of this type, and must have the information and tools
required for the proper performance of the task.
Also, the contents of Royal Decree 1627/1997, on minimum health
and safety provisions applicable to construction work, as well as in
Royal Decree 2177/2004, which modifi es Royal Decree 1215/1997,
which establishes the Minimum Health and Safety Provisions for Use
of Work Equipment by Workers, on the subject of temporary work at
heights.
Regulations also require mandatory use of personal protective
equipment adequate for the work to be performed, as described in
Law 31/1995 and its further development in Royal Decree 773/1997.
In cases where workers from multiple companies are active
concurrently, there must be coordination on the subject of prevention,
as defi ned in article 24 of Law 31/1995 and its further development in
Royal Decree 171/2004.
To Next Page
Loading...