Alstom Drive Data Manager ALSPA MV3000 - Enclosure Mounting Instructions; Template and Drilling Procedure; Seal and Component Fitting

ALSPA MV3000 Drive Data Manager™ Lead/Mounting Kit
Instruction Sheet T1916EN Rev. 0002 (07/00)
Page 3 of 8
Fitting Instructions For Enclosure Operation Of The Drive Data Manager™
CAUTION
Do not photocopy the template as it may change size. Only use the template provided by
=>?@.
• Using adhesive tape, fix the drilling
template in position on the enclosure.
• Drill four holes of 4.5mm diameter as
shown on the template, taking care not
to get swarf inside the cubicle.
• Drill the 35mm hole marked on the
template. Take care not to get swarf
inside the cubicle.
• Remove the template from the enclosure.
• It is recommended that the holes are de-
burred and painted at this stage to
prevent corrosion.
• Fit the seal to the Drive Data Manager™
ensuring that the six raised points of the
seal are located into the corresponding
holes on the Drive Data Manager™
Continued….