Alstom Drive Data Manager ALSPA MV3000 - Hand-Held Operation Instructions; Connecting the Extension Lead; Customer Support; Technical Support and Training

ALSPA MV3000 Drive Data Manager™ Lead/Mounting Kit
Instruction Sheet T1916EN Rev. 0002 (07/00)
Page 6 of
of of
of 8
Fitting Instructions For Hand-Held Operation Of The Drive Data Manager™
• For hand-held operation of the Drive Data Manager™ fit the
extension lead as shown.
• Use the tab on the side of
the extension lead
connector to retain the
lead.
• The cable at the drive end should be fitted as per the
enclosure mounting instructions, using the 4-40UNC screw
locks to secure the cable.
Customer Support and Training
Please refer to your local technical support centre if you have any queries about this product.