Alstom Drive Data Manager ALSPA MV3000 - Page 5

ALSPA MV3000 Drive Data Manager™ Lead/Mounting Kit
Instruction Sheet T1916EN Rev. 0002 (07/00)
Page 5 of 8
• Fit the 4-40 UNC screw locks to the
drive.
• Route the Drive Data Manager™ lead
as required through the enclosure to
the drive.
• Open the yellow Control Door and
route the cable up inside the Control
Wiring area of the drive. The shroud
covering the Digital Outputs (TB1) may
have to be loosened to route the cable
behind.
• Plug the lead to the drive and secure
using the fixing screws provided on the
connector.
• The lead can now be attached to the
drive as shown using the Cable Tie
provided.
• Close the yellow Control Door.
• Enclosure Fitting of the Drive Data
Manager™ is now complete.