Content
Instruction Manual
D1821EN/01
8/8
10- 2013
© ALSTOM 2010. All rights reserved. Information contained in this doc ument is indic ative only. No representation or warranty is given or should be relied on
that it is complete or correct or will apply to any particular project. This will depend on the technical and commercial circumstances. It is provided without
liability and is subject to change without notice. Reproduction, use or disclosure to third parties, without express written authority, is s trictly prohibited.
GRID
Complementary installation procedure
The complementary installation procedure,
developed below , imposes a lifting equipment with the
following characteristics :
+
3,000 daN)
(minimum)
H+2m
H
Supporting frame assembly
L31- 138EN/03
Lifting and positioning the pole
L31- 200EN/06
Installation of terminals with preparation
of contact surfaces
L31- 504EN/03
Installation of capacitors
L31- 605EN/02
Installation of stress- shields
on the interrupting chambers
L31- 664EN/02
Coupling of column and chambers
L31- 7138EN/01
Installation of operating device
L31- 7902EN/01
Installation, continued
To Next Page
Loading...
