Altair WBP-200 User Manual

WBP-200
SINGLE CHANNEL WIRELESS BELTPACK
WB-200 SERIES WIRELESS INTERCOM SYSTEM
OWNERS MANUAL
AUDIO ELECTRONICS DESIGN
AUDIO ELECTRONICS DESIGN AUDIO ELECTRONICS DESIGN
AUDIO ELECTRONICS DESIGN
EQUIPOS EUROPEOS ELECTRÓNICOS, S.A.L
Avda. de la Industria, 50. 28760 TRES CANTOS-MADRID (SPAIN).
34-91-761 65 80 34-91-804 43 58 altair@altairaudio.com
www.altairaudio.com

Altair WBP-200 Specifications

General

Brand	Altair
Model	WBP-200
Category	Intercom System
Language	English

Summary

1. INTRODUCTION

2. SWITCHES, CONTROLS, ADJUSTMENTS AND CONNECTORS

FRONT PANEL

Details the switches, controls, and connectors located on the front of the ALTAIR WBP-200 beltpack.

REAR PANEL

Details the connectors and ports found on the rear of the ALTAIR WBP-200 beltpack.

3. OPERATION

HEADSET CONNECTION

Explains the TINY Q-G connector for headsets and microphones, including XLR pinout.

CALL SWITCH

Describes the function of the CALL switch, sending a signal to the base station and triggering alerts.

MIC ON/OFF/PUSH TO TALK SWITCH (TALK)

Details the operation of the MIC switch for enabling/disabling the microphone and PUSH TO TALK functionality.

BUZZER ON/OFF SWITCH

Explains how to enable or disable the buzzer sound for calls and key presses.

VOLUME UP/DOWN SWITCH

Describes how to adjust the headphone volume level using the dedicated switches.

ON/OFF SWITCH

Details the procedure for turning the beltpack on and off, and initial status indicators.

IN RANGE LED

Explains the IN RANGE LED's function, indicating the beltpack's proximity to the base station.

VIBRATOR ON/OFF

Describes how to enable or disable the vibration alert for incoming calls.

STANDBY MODE

Explains how to enter and exit standby mode to conserve battery power.

MIC GAIN ADJUSTMENT

Details how to adjust the microphone input gain level for optimal audio.

SIDETONE GAIN ADJUSTMENT

Explains how to adjust the sidetone level heard by the user in their headphones.

BELTPACK REGISTRATION

Guides on the process of registering the beltpack to a base station for wireless communication.

BELTPACK DEREGISTRATION

Describes how to remove a registered beltpack from a base station.

DC-IN CONNECTOR

Details the DC input connector for charging the beltpack's batteries.

4. SPECIAL OPERATIONS

ACTIVATING THE MICROPHONE PHANTOM POWER

Explains how to enable/disable phantom power for electret microphones using internal jumpers.

CANCELLING THE BUZZER

Details how to permanently disable the buzzer using an internal jumper.

CHANGING THE BATTERIES

Provides instructions for replacing the NiMh batteries in the beltpack unit.

5. SPECIAL RECOMMENDATIONS

6. BATTERY CHARGER ALTAIR WBPC-200

CHANGING THE VOLTAGE AND THE FUSE

Guides on how to change the charger's mains voltage setting and replace the fuse.

CONNECTING TO THE MAINS

Explains the proper procedure for connecting the battery charger to the AC mains power.

BELTPACK BATTERY CHARGE

Details the process for charging the beltpack batteries using the WBPC-200 charger.

7. TECHNICAL SPECIFICATIONS

8. WARRANTY