EasyManuals Logo

Altec Lansing ATP3 User Manual

Altec Lansing ATP3
4 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Figure 2
ATP3 Setup Instructions
LEFT RIGHT INPUT
LEFT RIGHT INPUT
LIME
Set Up Instructions
(See Figure 2)
Do not insert the AC power
plug into the wall outlet
until all connections are
made.
Make connections as shown in
Figure 1.
1) Connect the LEFT SATELLITE
SPEAKER to the SUBWOOFER.
Connect BROWN PLUG from the
LEFT SATELLITE SPEAKER into
the jack on the subwoofer
marked LEFT.
2) Connect the RIGHT
SATELLITE SPEAKER to the
SUBWOOFER. Plug the speaker
wire with the ORANGE
connector into the
corresponding jack on the back
of the subwoofer marked RIGHT.
Note that this connector has an
arrow on it. This arrow should
face up as shown in Figure 1.
3) Connect the SUBWOOFER to
the computer. The lime color-
coded wire connects the input on
the subwoofer to the audio output
on your computer.
ORANGE
BROWN

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Altec Lansing ATP3 and is the answer not in the manual?

Altec Lansing ATP3 Specifications

General IconGeneral
Speaker Type2.1 Speaker System
Input3.5mm stereo mini-jack
ControlsVolume, Bass
Signal-to-Noise Ratio>70 dB
Input Impedance10 kOhms
Satellite Power Output6 Watts RMS per channel
Subwoofer Driver6.5 inch
Satellite Drivers2-inch

Related product manuals