Altec Lansing IMT702 - Listening to a Non-Docking Ipod or Other Portable Audio Device; Maintaining Your Speaker System

13
Listening to a Non-docking iPod
or Other Portable Audio Device
Ifyouhaveanon-iPodMP3playerorothernon-dockingportableaudio
device, you can enjoy it through your Altec Lansing inMotion Max speaker
systemaswell.JustconnectitviatheAUXjack.Here’show:
1 Locate a 3.5 mm stereo cable
(not included).
2 Plug one end of the stereo cable
into your device.
Your device should have either a
headphoneorLINEOUTjackforyou
to plug into.
3 Plug the other end of the stereo
cable into your speaker system’s
AUX jack.
The AUX jack is located on the back of the unit.
4 Select “AUX” mode.
Press the
button on your speaker system or the enhanced
remoteuntiltheAUXiconappearsonthespeakersystem’sLCD.
5 Turn on your device and start it playing.
6 Adjust the volume.
Usethe+and–buttonsonthespeakersystemtoadjustthevolume.
Or,usethe+and–buttonsontheenhancedremote.
NOTE You may need to adjust the device volume also. Your device’s
volume should be set to approximately ¾ volume.
7 When you are finished listening to your portable audio device,
please remember to turn both it and your speaker system off
to conserve electricity.
Place your speaker system on a level surface away from sources of direct
sunlight or excessive heat.
Protect your furniture with a cloth or other protective material when placing
your speaker system on a natural wood or lacquered finish.
Cleanyourspeakersystemwithasoftclothmoistenedonlywithmildsoap
andwater.Strongercleaningagents,suchasbenzene,thinnerorsimilar
materials, can damage the surface of the unit.
Maintaining Your Speaker System