Setting Up the Alarms
Your device can also be used as an alarm clock, with two separate alarms that can each be set. Read the
steps below for an explanation of how to set alarm 1. To set alarm 2, follow the same steps using the AL2
button.
1. Press and hold the AL1 button for 2 seconds until the alarm time flashes on the display screen.
2. Press the + or – Buttons again to adjust the desired alarm clock hours (hold for rapid setting).
3. Press the AL1 Button again to bring up the clock minutes.
4. Press the + or – Buttons again to adjust the desired alarm clock minutes (hold for rapid setting).
5. Press the AL1 button to confirm the alarm time setting. Next you can choose which audio source will be
used as the alarm sounds.
6. Press the + or – buttons repeatedly to select a desired audio source for the alarm. You can
choose amongst the following options: bb (buzzer), bt (Bluetooth) or RADIO (FM radio).
bt: You will wake to the currently linked Bluetooth device. If no device is detected, the default buzzer will sound instead.
Radio: Press the + or – buttons to tune the radio to the station you’d like to wake up to before turn off the unit.
bb: You will wake to the buzzer alarm.
7. Press the AL1 button to confirm which audio source will be used as the alarm sounds. Next, the alarm
volume display will flash. Press the + or – buttons to increase or decrease the alarm volume setting.
Press the AL1 button to confirm. The alarm icon will remain on the display screen, indicating the alarm is set.
Notes: setting the alarm clock must be on standby mode.
To Next Page
Loading...
