28
5. Close the door once the fi re is burning
well. At the same time the grate closes
almost completely.
Let the stove burn out and cool down.
Repeat this ten times. Between two
burning procedures, remove any excess
ash from
4. Leave the door slightly ajar, the grate
will stay slightly open.
Leaving the door slightly ajar after
lighting prevents creosote from depositing
on the glass. Creosote causes stains that
are diffi cult to remove.
45
1. Shake the grate to clear any excess ash
into the ash pan and empty the ash pan if
required. NB: There may still be glowing
embers present in the ash for up to
twenty-four hours after the stove has been
put out. Always empty ash remains into a
fi reproof container.
Ensure maximum airfl ow by opening the
grate and air valve. Please refer to Figure
C. The ash pan should always be closed
while adding wood.
Lightning instructions
The stove can be used as normal once the initial lighting procedure has been completed.
1
To Next Page
Loading...