20
To Set up:
Insert stereo patch lead into the output (2) of the BT Pro LCD unit.
Insert the other end into the input of the black TMS device.
Insert the Magnacoil into the “Coil” output on the black TMS device.
Plug the 24 volt power supply into the black TMS and plug into mains power to operate.
BE SURE TO USE ONLY THE POWER SUPPLY THAT CAME WITH EACH DEVICE!
Do not mix the power supplies up as some devices require different voltage power.
The TMS device acts as an amplifier that sends the frequencies to the Magnacoil.
A magnetic frequency is emitted from the Magnacoil.
Sit or lie in a comfortable position and place the Magnacoil next to you or on top or underneath
your body.
The TIME is fixed to 3 minutes for each frequency.
You can run each frequency continuously by pressing SELECT while that frequency is running.
This pauses the 3 minute timer but allows the frequency to continue from the output until
SELECT is pressed again.
Turn the intensity up to 3/4 or full (75%-100%).
Because no timer is set for this function, you will need to manually switch the unit off
24volt Charger
Cable from Magnacoil
MAGNACOIL
Stereo patch cable
To Next Page
Loading...