address. And a description of the problem.
Repair Status
The current repair turnaround time for altimeter repairs can be checked on the Aalti-2 Inc
Web Page, http://www.alti-2.com.
Status on your altimeter can be checked by contacting the Alti-2 Inc. Repair Department,
or by initiating a Request for Repair Status through the Alti-2 web-page.
MODEL SPECIFIC INFORMATION
Altimaster II
Additional checks to ensure operation:
Do not block the small air hole on the back side of your altimeter. Free air flow through
this hole is critical for proper operation. Do not attempt to clean this hole with
compressed air or with any sharp object. Use of light suction to clean this hole is
acceptable. If this area has been damaged or blocked, your altimeter should be
returned to ALTI-2 for service.
Inspect the small O-Ring located at the base of the calibration knob regularly. This ring
is used to provide friction and reduce the chance of inadvertently changing the
calibration of your altimeter. If it is damaged or you find that the calibration knob turns
too easily or is difficult to turn, you should return the altimeter to Alti-2 for service.
If the lens becomes scratched excessively, it will obscure your view of the needle and
faceplate, you should return the altimeter to AltiI-2 for service.
Adjusting the Altimaster II Altimeter
This is accomplished by rotation of the knob positioned on the outside of the case. Prior to
usage, rotate this knob until the needle is in line with the number zero on the faceplate.
Mounting the Altimaster II:
The Altimaster II can be mounted using a wrist strap or chest mount.
Wrist Mount – The Altimaster II can be mounted on a wrist using the Velcro Wrist Mount
Kit.
To Next Page
Loading...
Need help?
General