6 | INSTALLATION
iNstaLLatioN
There are two ways to install this headrest in your vehicle: you can
do it yourself, or you have it professionally installed by an auto
specialist.
NOTE: The shape and the size of the headrest may not be suitable
in all cars. Please check the dimensions before installing.
Install it yourself
1. Remove the original headrest of your car.
2. From the 6 pairs of installation tubes (16/14/13.8/12.7/12.5/12
mm in diameter) included in the product, select the correct pair
for the poles of your car’s headrest.
3. Adjust the space between the two poles of the headrest, and
install the headrest in position and adjust its height as required.
4. Run the radio antenna and AV cable through the seat’s pole.
5. Insert the car power adaptor into the car lighter port of your
car.
6. Connect the DC connector of the car power adaptor (included)
into the DC in port of the headrest DVD player.
12V DC In
12V Car Adaptor Port
To Next Page
Loading...