V E N T L E S S H O O D O P T I O N
#852 • AR-7E Rotisserie Opera ti on & C ar e Ma nual • 3 6
H O O D O P E R AT I O N
E L E C T R I C A L C O N N E C T I O N
1. An identification tag is permanently mounted on the back of the ventless hood.
2. The interconnect cord from the ventless hood to the rotisserie oven provides full power connection.
U N PA C K I N G & S E T- U P
T
he Alto-Shaam Ventless Hood has been thoroughly tested and inspected to ensure only the highest quality
unit is provided. When you receive your hood, check for any possible shipping damage and report it at once
t
o the delivering carrier.
S
ave all the information and instructions packed inside the carton. Complete and return the warranty card
to the factory as soon as possible to assure prompt service in the event of a warranty parts and labor claim.
NOTE
: All claims for warranty must include the full model number and serial number of the hood.
The Ventless Hood is factory installed directly on
the top of the Alto-Shaam® Rotisserie oven. The
hood is designed to vent clean air back into the
kitchen, filtering vapors and grease. A high-power
fan draws fumes and steam into the hood intake and
out the top surface exhaust vent. Fumes and vapors
are circulated through filters draining the
condensation through a drain into the rotisserie drip
pan. An activated charcoal filter cleans the air before
venting it out the top of the hood.
Turn the ventless hood ON before operating the
rotisserie oven. There are a number of safety features
incorporated into the operation of the hood which are
directly related to the interaction of hood function and
the operation of the rotisserie oven.
VENTLESS HOOD INTERLOCK SWITCHES
— CHARCOAL FILTER SWITCH
GREASE FILTER SWITCH
Prevents both hood and oven operation if any filter
is not in place or is improperly installed.
— FAN PRESSURE SWITCH: Prevents rotisserie
oven operation if hood fan is not operating or if the
filters are more than 25% blocked.
TIMED LATCHING MECHANISM
— In order to evacuate grease-laden air
and steam from the oven interior, this mechanism
briefly prevents the operator from fully opening the
rotisserie oven door. The mechanism automatically
disengages at the end of a pre-set time allowing full
door extension. (NOT AVAILABLE ON 230VAC HOODS)
RESET SWITCH
— The Reset has to be used if the rotisserie oven is
turned on before the hood or if the hood was opened.
It resets the pressure switch circuit and provides
power to the rotisserie control circuit. This switch
must also be used to reset hood controls after any
problem with the filters, or the improper latching of
the ventless hood door. See illustrations on following
pages of this manual.
FAN
INDICATOR LIGHT
Illuminates when
fan is running.
DOOR LATCH
INDICATOR LIGHT
Illuminates when
latch is engaged.
ON/OFF SWITCH
RESET BUTTON
Press after correction
of any problem with
hood or oven.
VENTLESS
HOOD
CONTROL
To Next Page
Loading...
