INSTALLATION
Vecto r H® S eries ▪ Operat or’s M anual ▪ M N-46 2 95 ▪ Rev 7 ▪ 6/22
47
Continued from previous page
2. Level the unit as necessary. To do so, screw the wheel up or down until the
unit is level. Tighten the jam nut
c.
Slide a piece of the tubing d over the exposed screws if more than
1/4-inch of thread is exposed.
Attach wire tie e around the tubing to hold it in place.
Install the tether 3. Install the tether to the lower oven. Install the tether so that no stress is
transmitted to the electrical cord when the oven moves.
Result The casters are now installed.
To Next Page
Loading...
