Page -9- WAP TECHNOLOGY Wet/Dry Vacuums Operator's Manual
MACHINE OPERATION
Changing The Bag Type Filter
1. Close the bag-type filter sleeve with the slide
(Figure 9).
2. Pull the bag-type filter sleeve off the inlet fitting.
3. Dispose of the used bag-type filter in accordance
with the local waste disposal regulations.
4. Place a new bag-type filter into the tank as de-
scribed in the instructions printed on the filter.
IMPORTANT!
Push the bag-type filter sleeve completely
onto the inlet fitting.
Replacing The Filter Element
1. Switch off the machine and pull the plug of the
power cord out of the plug socket.
2. Remove the machine top section from the dirt tank
and place to one side with the filter element facing
upwards (Figure 10).
3. Unscrew the filter retaining nut (1) and remove
together with the retaining washer (2).
4. Pull off the filter element (3).
5. Push on a new filter element.
6. Fit the filter retaining washer and tighten the
retaining nut.
7. Dispose of the used filter element in accordance
with the local waste disposal regulations.
MAINTENANCE AND REPAIR
CAUTION: Before cleaning and servicing the
machine, always remove the power cord.
Carry out only maintenance operations described in
these operating instructions. Use only original Wap
Technology spare parts.
CAUTION: Do not make any technical
modifications to the machine. Your safety
could be endangered as a result!
For all other maintenance and repair work,
please contact and authorized Wap
Technology Service department.
Figure 9
Figure 10
To Next Page
Loading...
Need help?
General
