22 P. AMP INPUT Jacks
These 1/4" phone jacks are used to input line level stereo signals to the built-in
power amplifier.
These 1/4" phone jacks are used to send out the signal from the AUX bus to external
devices such as effect units and/or stage monitors.
LAMP
(12V/0.5A)
AUX SEND1
AUX SEND2
ST OUT
LL
ST SUB OUT
L
FOOT SW
MONO OUT
PHONES
ST SUB IN3
R
(MONO)
L
R
(MONO)
ST SUB IN2
ST SUB IN1
R
L
(MONO)
L
RRR
P. AMP INPUT
DFX1 SEND
DFX2 SEND
28
25
21
22
23 24
26
29
27
SPOTLIGHT
4. CONTROL ELEMENTS
9
23 ST OUT Jacks
These jacks are used to output the signal of the STEREO bus. The final output
level from these jacks is adjusted by the ST OUT fader.
24 ST SUB OUT Jacks
These jacks are used to output the signal of the STEREO bus. Use the ST SUB
OUT control to adjust the final output level at the ST SUB OUT jacks. Generally,
it is available to connecting effects unit.
26 MONO OUTPUT Jack
Use this balanced MONO jack to connect the input of an external amplifier or
active monitor speaker.
27 FOOTSWITCH Jack
This 1/4" jack can be used to connect an external foot switch to turn on/off the
onboard effect module.
25 ST SUB IN 1-3 Jacks
These 1/4" jacks are used to connect stereo output of a sub mixer or external
effect processor. The signal input can be routed to the AUX1-3 bus and STEREO
bus.
21 AUX/DFX SENDS Connectors
To Next Page
Loading...
