Need help?Do you have a question about the Alto APX1000 and is the answer not in the manual?
General| Type | Power Amplifier |
|---|---|
| Power Output | 1000W |
| Channels | 2 |
| Built-in Effects | No |
| THD | < 0.1% |
| Signal to Noise Ratio | > 100 dB |
| Connectors (Outputs) | Binding posts, Speakon |
| Output Power (Bridged) | 1000W @ 8 Ohms |
| Frequency Response | 20Hz - 20kHz |
| Inputs | XLR, 1/4" TRS |
| Input Sensitivity | 0.775V |
| Input Impedance | 20 kOhms |
| Protection | Thermal |
| Weight | 25 lbs |
| Output Power (Stereo) | 2 x 500W @ 4 Ohms, 2 x 300W @ 8 Ohms |
Read safety and warranty information before using the product.
Ensure all devices are off and faders/gain knobs are set to 'zero'.
Connect sound sources' outputs to amplifier inputs as per the diagram.
Connect the amplifier outputs to your speakers.
Switch on sound sources, mixer, amplifier, and speakers in the specified order.
Turn off speakers, amplifier, mixer, and sound sources in the specified order.
Selects between Stereo, Parallel Mono, and Bridged operating modes.
Do not adjust mode switch when on. Avoid shorting terminals or connecting positive to ground.
Do not connect when powered on. Ensure wires do not touch, and positive output is not grounded.
To Next Page
