Need help?Do you have a question about the Alto MISTRAL 6000 and is the answer not in the manual?
Lists all necessary instruments for product testing.
Detailed steps and specifications for testing the product.
Power on sequence and initial LED status for finished products.
Testing output voltage and distortion with a 1KHz/3dB signal.
Specifies distortion, frequency response, and SNR limits.
Verifies limiter function and clip LED behavior at 1KHz/+10dB.
Tests bridge mode output voltage and distortion with an 8Ω load.
Tests limiter illumination and power consumption in short circuit.
Measures maximum output power consumption during short circuit.
To Next Page
General
