4
Quick Start
Items not listed under Introduction > Box Contents are sold separately.
Example 1
Connect a dynamic microphone to the Input 1 using an
XLR or 1/4” (6.35 mm) TRS cable. Connect a guitar with an
active pickup to the Input 2 using a 1/4” (6.35 mm) TS
cable.
Note: When using the TSL115 loudspeaker with a guitar,
we recommend using one with active pickups rather than
passive pickups. If you use a guitar with passive pickups,
connect it to an external preamp or direct input (DI) box,
and connect the line-level output to the loudspeaker.
Also, we recommend using dynamic microphones with the
TSL115 loudspeaker rather than condenser microphones. If
you use a microphone that requires +48V of phantom
power, we recommend connecting it to an external phantom
power supply before connecting it to the loudspeaker.
Example 2
Connect the left and right output of your DJ mixer, controller, etc. to Input 1 of each
loudspeaker using XLR or 1/4” (6.35 mm) TRS cables.
Tip: To send the same mix to both TSL115 loudspeakers, connect both channels of your DJ
mixer, controller, etc. to the Input 1 and Input 2 of one loudspeaker, and then connect that
loudspeaker’s Mix Out to the Input 1 of the other loudspeaker. Both TSL115 loudspeakers will
then play identical summed mono mixes.
MOOD
METER
MIX
PULSE
PARTY
MOOD
METER
MIX
PULSE
PARTY
MOOD
METER
MIX
PULSE
PARTY
To Next Page
Loading...
