Altronic DE-4000 - User Manual

DE-4000 Firmware Download Quick Start Guide
This quick start guide refers to several documents that will provide step-by-step procedures for
programming and downloading the support files for the DE-4000. (This document assumes that you
have exported a JSON file from the DE-4000 before you begin. If there is no configuration file started,
please ignore this.)
WARNING! Failure to properly follow these instructions may cause damage to the DE-4000 system.
NOTE: Basic understanding of DE-4000 operation and configuration is required. Reference from DE-
4000 OCM at http://www.altronic-llc.com/pdf/annunciators/DE-4000%20OCM%203-20.pdf.
You should have the following documents available for your reference:
ST-Link Procedure _R3.pdf
MicroSD SOM Update.pdf
Change IP Address.pdf
Pinging DE-4000.pdf
HARDWARE REQUIRED: 693225-KT, which includes the following:
Programming cable (Board to Adapter)
Programmer (Used with PC)
Programmer Adapter Board
SOFTWARE REQUIRED: ST-LINK V4.6.0
Please note the ST-LINK software can be downloaded from the Altronic website,
http://www.altronic-llc.com/catalog-downloads.shtml under Terminal Programs
Please perform the following steps in order:
1. Review document ST-Link Procedure_R3.pdf.
2. Review document MicroSD SOM Update.pdf. Remember, when loading 2.X firmware or
higher, you will be updating an “update.atf” file and a “kernel.atf” file that are located within
the root of the microSD card.
Note: The MicroSD card needs to be 32 GB or less. Larger capacity cards will not work
properly.
3. To properly set your computers IP address, please refer to document Change IP Address.pdf,
set your computer IP address to 98.102.65.200.

Summary

Reference Documents for DE-4000 Firmware Update

ST-Link Procedure Document

Document detailing the ST-Link procedure for DE-4000 firmware updates.

MicroSD SOM Update Document

Document for updating the DE-4000 MicroSD SOM, including file specifics.

Change IP Address Document

Document to guide users in changing their computer's IP address.

Pinging DE-4000 Document

Document providing instructions on how to ping the DE-4000.

System Requirements for DE-4000 Firmware Update

Hardware Requirements

Specifies required hardware, including a kit and programming components.

Software Requirements

Specifies the required ST-LINK software version (V4.6.0).

DE-4000 Firmware Update Procedure

Initial Setup and Review

Review ST-Link procedure, MicroSD update, and set computer IP address.

Controller Access and Configuration

Access the controller via web browser and locate system information.

Firmware Version Check and Import

Verify firmware versions and import the JSON configuration file.

Troubleshooting Firmware Update Issues

Communication and Download Problems

Refer to Pinging DE-4000 document for communication or download issues.

Altronic DE-4000 Specifications

General

Brand	Altronic
Model	DE-4000
Category	Control Systems
Language	English