DSC
®
Power Series
™
Programming
1. Set up an account in the AlulaConnect portal.
2. Add the MASTER CODE to the primary account user before connecting the BAT-Connect. This is
required for the BAT-Connect to be able to properly congure the system settings.
3. Disarm the system (all partitions).
4. Enter panel programming mode using the installer code and program the following:
5. Exit programming mode and power down the DSC system.
6. Connect the DSC system and the BAT-Connect as shown in the wiring diagram on the next page.
7. Power up the DSC system.
• The DSC control panel will begin automatic conguration. Panel keypads will be
unavailable during this time.
8. Verify proper operation and reporting of all event codes using your control panel’s installation
manual.
Note: During normal operation, BAT-Connect will occasionally use the panel bus for some system
tests. Typically, this lasts for 5-6 seconds. During this time, panel keypads will be unavailable.
Note: DSC Power Series panels may use different programming locations or the option
may not be available. Always refer to the installation manual of the specic panel for
programming locations and options.
• Enable Communicator ([380]:[1])
• Enter a Telephone Number ([301])
• Enter Account Number ([310])
• Verify 1st Telephone Number is enabled in Call Direction Options ([351]-[376])
• Verify T-Link is Disabled ([382]:[5])
• Verify Master Code Not Changeable is Disabled ([015]:[6])
• Verify Access Code Required for *1, *2, *3 menus is disabled ([022]:[1])
• Verify that keypad lockout is either zero (disabled) or higher than 6 ([012])
• If you have removed any bus devices, perform a Module Supervision Reset ([902])
• Set Communicator Format to Contact ID ([350])
• Verify the panel is properly set up for Contact ID event reporting
• To enable reporting of the Period Test Transmission, program the “Periodic Test
Transmission” ([348]:[4]) and the “Periodic Test Transmission with Trouble” ([348]:[3])
reporting codes to “02”(optional)
To Next Page
Loading...