What to do if my Alutech LG-800 Garage Door Opener motor runs but the door doesn't move?
If the drive runs after a command but the door doesn't move, it's likely that the drive rail carriage is not blocked. Block the drive rail carriage to resolve this issue.
Why is the light flashing on my Alutech Garage Door Opener?
If the drive light flashes after a control command, it indicates an error in the operation of the drive. Check the error display on the drive and repair the drive according to the error description.
General| Max. force | 800 N |
|---|---|
| Warranty | 2 years |
| Supply voltage | 230 V |
| Motor Type | DC |
| Power Supply | 230 V, 50 Hz |
| Control | Remote control |
| Installation Type | Ceiling mount |
Lists all components included in the drive set and drive rail kit for garage doors.
Details technical parameters for LG series drives and rails, including forces, speed, power, and operating conditions.
Provides step-by-step instructions for installing the drive rail and mounting the drive unit onto the rail.
Explains how to release the drive carriage for manual door operation, with safety precautions.
Details manual and automatic methods for setting the open and closed end positions for the garage door.
Guides through recording, configuring, and deleting remote controls for the drive system.
Explains how to delete specific remote controls or define their record numbers in the drive memory.
Provides steps to erase all previously programmed remote controls from the drive's memory.
Covers various operational settings like force, speed, acceleration, deceleration, and sensor modes.
Describes how to restore the drive's settings to their default factory values.
To Next Page
