Alva GH301 - Changing Your Cylinder; Maintenance

CHANGING YOUR CYLINDER
Make sure you cylinder valve is closed (by turning it clockwise).
Allow the heater to fully cool before replacing the cylinder.
Unscrew the regualtor from the cylinder and lift the cylinder
holder. (Figure I)
Remove and replace the cylinder. ALWAYS check that the reg-
ulator-sealing washer (nose cone) is intact and in place before
reattaching the regulator to a cylinder. (Figure B - Page 3)
DO NOT attempt to remove the regulator while the heater is on
or if the cylinder valve is not closed.
MAINTENANCE
• Always make sure the heater is
OFF and cool, with the cylinder
valve closed, before conduct-
ing any maintenance.
• Your heater should be checked
once a year by a qualied
technician.
• If faults are suspected or
detected, stop using the heater
and contact ALVA.
• Clean the exterior and stor-
age area of your heater when
required to remove dust and
prevent lint build up.
• DO NOT use abrasive products
to clean the heater; these may
damage the paint work.
• While in operation the pilot
ame should be steady. If it
ickers or is yellow the heater
needs to be serviced. (Fig. I)
Fig.I
Core
GOOD
BAD
Not enough air
BAD
Too much air
7
Fig.I