Alva GH301 - Method of Assembly; Heater Set Up

METHOD OF ASSEMBLY (USE WITH PARTS LIST)
This heater makes use of a
domestic cylinder (3kg or 4.5kg
ALVA cylinder recommended) with a
3/8” BSP thread vertical exit valve.
The L-shape regulator supplied with
the heater tightens to the left hand
side (clockwise). (Figure A)
If you have bought a new gas cylinder, the cylinder needs to be
purged (cleared out), before it’s rst use. If it is not purged of air,
the heater will not work properly. This should happen at the gas
lling station when you ll up the cylinder. Always check this with
your gas supplier.
HEATER SET UP
1. Before removing this heater
from the packaging, read this
manual in full and make sure
that it is what you want /need.
2. Remove the heater from the
packaging.
3. Check if the nose cone is
present, secure and in good
condition. (Figure B)
WARNING
This heater operates
directly on a domestic
cylinder with a 3/8”
VERTICAL exit valve.
(ALVA 3kg or 4.5kg
domestic size)
It is NOT to be used
with a 5/8” HORIZONTAL
exit valve.
3
Fig.B
Fig.A
Regulator
sealing washer