What does it mean when Amada HFA-400W Saw displays alarm code on LCD screen?
If an alarm code is displayed on the LCD screen, it indicates that the machine is malfunctioning. To address this, clear the alarm by referring to the alarm code list.
What to do if E-113 Motion detector actuated during Amada Saw operation?
If error E-113 occurs, indicating the motion detector actuated during operation, it might be because the saw blade slipped. Check the saw blade tension, clear the alarm, and reduce the cutting rate to decrease the load.
What to do if Amada HFA-400W Saw vises do not open wide?
If the front and rear vises do not open wide enough, it might be because the sawhead is too low. Press and hold the BLADE UP button to raise the sawhead to its upper limit.
What does E-011 error mean on Amada HFA-400W?
If the Amada Saw displays error E-011 (option), it indicates that during head-end positioning, the work projection from the rear vise is 20 mm or less. To resolve this, clear the alarm and properly set the work.
What to do for Amada Saw E-009 error?
If the Amada Saw displays error code E-009, it means the backup battery for cutting data setting controls has run down. Clear the alarm.
What to do for Amada HFA-400W Saw E-008 error?
If the Amada Saw displays error code E-008, it indicates that the PLC backup battery has run down. Clear the alarm.
What to do if the Amada HFA-400W blade runs out or breaks?
If the saw blade runs out or breaks, consider the following potential causes and solutions: * The cutting rate might be too low. Try turning the FLOW CONTROL dial toward “10”. * The saw blade tooth pitch or tooth form might not be appropriate. Select another saw blade. * The saw blade tooth pitch might be too fine or too coarse for the width of the work. Select another saw blade. * The saw blade teeth might not be offset equally or are unevenly worn. Change the saw blade for a new one. * The saw blade tension might be too low or too high. Retension the saw blade, check the hydraulic pressure and cylinder. * The saw blade might be improperly set. Adjust the saw blade so that it runs in the proper position. * The sawhead might knock. Remove air from the lift cylinder. * The ...
Essential safety rules to prevent injuries and accidents during machine operation.
Guidance on selecting saw blades and appropriate cutting methods for safe and efficient operation.
Guidelines for installing the machine on a firm, level floor with adequate space.
Instructions and warnings for safely carrying the machine using a crane or forklift.
Procedure for ensuring the machine is properly leveled using spirit levels.
Guidelines for connecting electrical power, emphasizing the need for a qualified electrician.
Step-by-step instructions for connecting the machine's power cable.
Explanation of the control panel layout, including lights, buttons, and LCD screen.
Details on controls for setting and managing cutting data, including station and length settings.
Adjusts saw blade pressure against the workpiece for efficient cutting.
Adjusts the downfeed speed of the sawhead during cutting operations.
How to adjust saw blade guides to suit work width and ensure proper guidance.
Procedure to adjust cutting fluid discharge using throttle valve and three-way cock.
To Next Page
General